news

1. The coil is overheated and burned out
(1) If the use time is too long and exceeds the allowable range, the coil should be replaced with a new one and the conditions of use should be improved.
(2) The armature is crushed to death under long-term energization. The head should be cleaned or the position of the armature should be adjusted.
(3) The coil insulation is aging or the coil is vibrated to short-circuit the internal turns. The coil should be replaced with a new one and fastened firmly.

2. There is no sound and no action when the power supply is connected
(1) The moving contact of the switch is fatigued and inelastic. Replace the switch or replace the moving contact piece.
(2) The power cord is twisted and the connector is loose. Replace the power cord or re-tighten the connector, and wipe off the sludge at the connector.
(3) There is dandruff in the switch, which causes the power supply to be cut off. Use a brush to remove dandruff.

3. There is electromagnetic sound when the power is turned on, but the clipper does not work
(1) There is too much dandruff on the upper and lower blades, and they are stuck, and the dandruff should be removed.
(2) The plate screw is too tight. The upper and lower blades should be adjusted according to the moderate tension.

4. Do not eat hair
(1) The angle of the elbow head has changed. Adjust the angle of the angled head to about 45 degrees.
(2) The angle head screw is loose. The angle head screws should be tightened.
(3) The adjusting screw and ingot screw are loose. The screw should be readjusted to suit the vibration of the angled head.
(4) The gap between the upper and lower JJ j1 is too large. should be newly adjusted) J-piece screws.

5. No sharp thorn The blade edge is worn. Regrind the blade or replace it with a new one.

6. Loud The screw spring adjustment is not good. Update the adjustment screws.

7. Leakage
(1) The insulation of the coil lead wire is damaged. Reprocess pinout insulation.
(2) The power cord is twisted and damaged and the interior is damp. Replace the power cord with a new one and re-insulate it.